Wakizashi 40 Keyboard
Description
#Required parts - M3 12mm x 6 - M3 16mm x 6 - Teensy2++ controller - (Optional) USB breakout board to glue to the case - MX style switch x 45 - 2u plate mount Cherry stabiliser x 2 - Diodes (I used 1N4148) x 45 #Printing Flip the plate pieces upside down so there are no overhangs. Make sure the pieces are flat on the print bed. #Wiring Follow the wiring diagram and wire to your Teensy2++ as follows. You can use a Teensy2.0 or Pro Micro etc but you'll need to edit the pin numbers in firmware and change the mcu to atmega32u4.   #Firmware If you are using a Teensy2++ and have wired it according to the above diagram, go ahead and download the hex file from the file section and flash it. My compiled hex is built with via support but until it is merged with the via repository, you'll have to use [Vial](https://get.vial.today/) and sideload [this json file](https://github.com/xia0/keyboards/tree/master/src/handwired/wakizashi40). If you need to edit the source, it is [available on github](https://github.com/qmk/qmk_firmware/tree/develop/keyboards/handwired/wakizashi40) (currently in develop branch, link will break once merged into master).  # [Clueboard 66%](https://www.thingiverse.com/thing:3010436) [](https://www.thingiverse.com/thing:3010436) If you want something bigger, take a look at my 3d printed Clueboard.
Statistics
Likes
40
Downloads
0