revision-w-fastener-bunny_shapeed_enclsoure_for_uIEC
Description
a friend asked me to make this for him. while setting up to print I noticed there was no real good way to put it together, so I added an area with a hole to screw the two pieces together. The hole is 3/16th diameter, this should allow you to use metric or SAE fasteners. I also made some of the walls thicker. I added a 0.2mm bridge across the screw hole but I use supports anyway. you will need a knife to cut the material out to use the screw holes. link to the original thing here: https://www.thingiverse.com/thing:2184386
Statistics
Likes
1
Downloads
0