Table stand for MCO Home - CO2 Sensor for Z-Wave
Description
I'd appreciate if you post some makes here! ;-) I bought the MCO Home - CO2 Sensor for measuring the air-quality in our bedroom during the night. Unfortunately it is intended to be mounted to the wall, which I did not want for two reasons: 1. Ugly holes in the wall and where to route the cable? 2. I may use it in any other room for a little monitoring, which is impossible when attached to the wall. So I designed this stand, which prints in ~4-5h does a decent job in holding it on any table or shelf. Please see the print settings - the STL orientation is not correct!
Statistics
Likes
2
Downloads
0