Star Wars Figure Display Stand IKEA Billy Book Case
Description
A modular display stand for Star Wars Figures. Designed to be printed in sections at low print resolutions, so a quick printing piece. 8 sections will fit the width of an IKEA Billy Book Case. You will need to print multiple pieces for each section The orange inset, is a piece of styrene, painted, trimmed and super glued behind the face. All pieces fit together with no glue. No printing supports are needed, just print face down on the print bed for a smooth finish. Will eventually upload a new connector, that is sized to the exact size needed. I uploaded new photos, this is photos of my second version. Version 1 needed too many pieces to be glued together and wasn't easy to line up. Version 2 fits together pretty well, even on low res versions. Eventually I would like to add a connector for the first and last pieces, to tie them to the rest of the stand. But, works fine without it, just tough to get the build started. I do recommend building from the middle out.
Statistics
Likes
83
Downloads
0