CASE for Low Noise RF Amplifier (With battery compartment)
Description
This is 3D printable case for an eBay cheap RF amplifier (gain 30dB) which can be used as part of EMC test toolchain. Part of the case is Li-Ion battery compartment so the amplifier can run w/o any external power supply (even lower noise!). Part of the design is also 5.5x2.1 charging barrel connector. Apply 8.4VDC maximum to this input in order to charge the batteries. Very good example o how to use the amplifier for EMC measurements during pre-compliance testing: EEVBlog: https://youtu.be/2xy3Hm1_ZqI reference: Designed for this amplifier: https://www.ebay.com/itm/0-1-2000MH-z-RF-Wideband-Amplifier-low-noise-LNA-Broadband-Module-Receiver-30dB/202371600929?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649 Used batteries (2pieces): Cellevia EEMB LP603449 (1050mAh-1100mAh): https://www.soselectronic.com/products/eemb/lp603449-1-157437 Used barrel connector (5.5X2.1MM).It is necessary to cut off left part of the flange. See picts. : https://www.gme.cz/napajeci-souosy-konektor-ds-225a Used power rocker switch (dimensions 10.5x15mm): https://www.gme.cz/p-sm101-1b3
Statistics
Likes
2
Downloads
0