2in1 & 4in1 Splitter
Description
This is a 2in1 and 4in1 Splitter for PC4-M6 push through fittings. There are two versions of each splitter. One with a M10 threat on the outside to screw into the hotend and the other one with a M6 thread on the inside for another PC4-M6 push through fitting. The filament path inside the splitter is a bit wider than a normal PTFE tube to prevent clogging inside the splitter (2in1 2.3mm/ 4in1 2.5mm). I also added a Nema 17 mount for 2020 extrusion (M5x12mm, M5 T-nut, M3x12mm, M3 hexnut needed). I used the Multi MCU feature of Klipper and an Arduino with a CNC shield to controll the added extruders.(Don't forget to set the jumpers for the motor steps on your CNC Shield) If you are also using Klipper you have to set the "max_extrude_cross_section" to a higher value, otherwise you will get an error at the filament change.
Statistics
Likes
151
Downloads
0