HE3D K280 K200 Board Cooler with Dual 50mm Fans
Description
I had a print stop at 80% and someone had said it could have been because the board got hot. After that I made this in Tinkercad. I have the fans pulling air in so that it brings air in from the outside between the 20mm rails. I also insulated the button of the heated bed which increased bed heating times and helps to keep heat away from the board. Since this mounts to the 2020 rail, if your bed mounts directly to the 2020 rails this will NOT work. If you have some sort of bed supports then this should work. My k280 came with a piece of wood that was packed with the glass bed, I used this wood as a bottom for the printer and this cooler sits and rests on that piece of wood. With that said if you don't have some sort of bottom cover, use the screw mount version. If you have some sort of bottom for your printer you can use the clip on or screw mount. I printed the first few layers in silk blue and the rest in clear PLA. I want to add LEDs eventually and make it light up! Printed at 0.2mm, 20% Infill. You will need to add supports for the fan mount square holes.
Statistics
Likes
7
Downloads
0