Prusa MK3 Bear Temperature and Voltage LCD
Description
This is a Mount for a simple Voltage/Temperatur display (LED or LCD) to mount on the end of a 2040 V-slot extrusion, like on the Prusa full bear upgrade. I use it to control the temperature inside of my enclosure. Get a cheap sensor, which measures voltage and temperature. Since it can handle >24V i just connected it to the power input of the einsy board, but works for 12V as well. You need to print front and back cover and 2 15-20mm M2 screws. If you have trouble, getting the LCD inside the front cover, set xy-compensation to -0.1mm in your slicer. It is a tight fit...
Statistics
Likes
11
Downloads
0