Sensible PSVR Camera Mount Cup
Description
Make your PlayStation VR experience more sociable by moving out of the way of the TV. The standard PSVR stand does not allow you to point the camera off to the side, so non-players can only stare at your backside. This little cup and hinge based design allows you to point the camera in any of 12 directions, while the hinge allows you to compensate for the angle of your TV (if like mine you have it mounted up on a wall and tilted down slightly). You'll need the following to complete the build: * Adhesive Pads (I recommend 3M Command Strips Poster Size) * 25mm M5 bolt and a nut Bolt the pieces together before you stick it to the back of the TV. Line it up with the top of the TV bezel which should be level, and then adjust the angle so that it's horizontal. Poke the end of the PSVR camera mount into a suitable slot and you're good to go. It's a bit of a tight squeeze, but the end of the foot is rubber so it should be okay. If you've got enough friction i guess you could technically mount this under the TV too. I take no responsibility if your camera drops on the floor at any point. Probably worth attaching the cable to something as a backup. **Happy PSVRing to the side**
Statistics
Likes
96
Downloads
0