Trigger-Clamp 3mm Bowden Extruder for Planetary Gearbox BSP
Description
This Started Out As The May 2012 Version Of An Airtripper Extruder, Then Was Modified By Piit79. I Just Added Some Support To Beef It Up A Bit, Added A Bsp Mount, Couple Thin Pads To Help With Bed Adhesion And Made Some Room For The Clamp Http://Www.Irwin.Com/Tools/Clamps/One-Handed-Micro-Bar-Clamps. The Goal Was To Make Something Close To The Current Airtripper Bsp I Use On My 1.7Mm Extruders But Modified For 3Mm Filament And With The Mount For A Kysan Geared Stepper Planetary Gearbox. Http://Airtripper.Com/1764/Airtrippers-Direct-Drive-Bowden-Extruder-V3-Bsp-Edition/ I Never Liked Using The Screws To Tension The Idler In Most Extruder Designs, It Is Just Too Much Trouble To Open And To Make Adjustments. So I Dropped The Hose/Springs And Long M3 Screws In Favor Of A Irwin Quick-Grip Trigger Clamp. For This Extruder I Made Some Small Adjustments To Make The Clamp Fit Even Better. I Did End Up Keeping One Of The Two Tension-Screw-Holes To Leave Room For The Allen Wrench For Mounting.
Statistics
Likes
5
Downloads
0