Wanhao D7 Easy Level Build Platform with Resin Drain
Description
A while back another user posted an easy level build platform that this is based on. The original is not on Thingiverse any more, so I can't give the original designer their credit, but I would if I could. This platform is mainly based on theirs, but will fit v1.5 machines (The original was too big in the Z axis) as well as earlier machines. There are also two versions of the bottom part, one to fit the original build plate, the other to fit the v1.5 build plate. The design incorporates bevels to allow resin to drain off the top a little easier, and the centre has been opened out to increase the volume of resin that can be used in the vat. It requires: One M10x40 bolt One M5x80 bolt One M10 nut One M5 nut 30/04/19 - I've updated the knobs and top to be more v1.5 friendly. The main reason was to keep my fingers out of the resin when tightening the tensioner knob. The requirements have changed: Top v3 is for pre-1.5 machines ONLY Top v4 is for v1.5 machines ONLY replace the M10x40 with an M10x25 bolt replace the M10 nut with an M10x4mm nut - these can be found on AliExpress, they are M10 thread, but only 4mm thick and 14mm over the flats
Statistics
Likes
13
Downloads
0