Mini Extruder for E3D Hobb Goblin (Tantillus Reborn)
Description
Remix of the original extruder for the awesome Tantillus Reborn by Lars. Check out www.scheuten.me for the Tantillus R project! I didn't like the original extruder with the MK7 gear and squished bowden tubes. So I remixed the extruder to be able to use a regular PC4 push fitting and the grippier E3D Hobb Goblin gear. The extruder consists of 1 Body, 1 Cover, 1 idler and the acrylic lid (optional). How to: Use the screws, bearing, springs etc from the original extruder, add 1 x PC4-M6 push fitting. - Insert M3 nut into nut trap, insert screws and spring (like in the original assembly) - Insert the lever with the installed bearing. - Slide a short piece of ptfe tube into the extruder body from the bottom right up to the inner housing, it will hold due to friction. - Pre-thread the top hole with M6, screw in the push fitting and insert bowden tube until you reach the inner housing - Put on the lid and the acrylic plate (from the original extruder) - Screw it to the Tantillus enclosure - Don't forget to adjust the e-steps for the new gear! BOM for those who don't have the original extruder: - printed parts - MR105ZZ bearing - 4x20mm cylindric metal shaft - PC4-M6 Push fit - 1 x M3 hex nut - 1 x DIN912 M3x20 - 1 x DIN912 M3x8 - 1 x DIN912 M3x30 (possibly shorter if you dont use the acrylic lid) - 1 x 0,8 x 4,7 x 20mm spring (or similar dimensions)
Statistics
Likes
2
Downloads
0