Bullet Feeder Die .223 / 5,56

Bullet Feeder Die .223 / 5,56

Description

Hi Folks, as i were going to load some .223 i was searching for a bullet feeder die on my Hornady LNL AP, like the 9mm one i remixed this from. Unfortunately i didn't find one. So gotta do it myself and here it is. Tried with 62gr. FMJ-BT bullets and works like a charm. You will probably have to sand the parts/holes a bit to get smooth sliding. 1x 4mm ball bearing is needed! ----------------------- The Catcher is designed to be mounted beneath the spring from an automatic bullet feeder. Holes are for an LED and photo diode. Use something like this: https://www.ebay.de/itm/163572021964 and a 4mm Diode on the other side. You can leave this if you feed bullets manually. ----------------------- You can either print the "Full" file. Or both parts separatly. (Jetfunel / Tube) If you like the design feel free to leave a like or donate some peanuts! ;D

Statistics

Likes

85

Downloads

0

Category

DIY