OnePlus 6 Orzly Case phone mount.
Description
For a OnePlus 6 with the Orzly Fusion Bumper case. Affiliate link: https://amzn.to/2XcEG0H non-Affiliate link: https://smile.amazon.com/Orzly-OnePlus-SmartPhone-Protective-Absorbing/dp/B07D4MDMD1/ **Make sure you use PETG or ABS or another higher temperature plastic as PLA will just warp and melt if left in the sun.** This is a phone holder I designed to go on the Proclip USA swivel in my car. It is a semi work in progress, I have not printed it myself yet but will be in the next few days. Holes for screws are 30mm x 38mm to mount to a swivel. The Rear camera will work. I am using this in combination with a dash mount I designed for a Miata at autocross events to for data logging using Solostorm. ** update 21-5-2019 ** - Fixed sizing of the holder. - Reduced the catch lip, it was a bit much and overstressing the print when trying to remove the phone from it. - Added version with the mounting holes in the center. ** Update 22-5-2019 ** - Adjusted sizing to better hold the phone, it was a little loose on the latest test print. ** Update 23-5-2019 ** - Adjusted sizing one last time and fixed the camera hole not being centered. my print of this turned out great and fit great.
Statistics
Likes
11
Downloads
0