LED Solar light hood for planter
Description
4/18/2019 1730 Added the 2inch and 3inch risers with two splits since I'm working with a different PLA that shrinks a bit and the split ends can help with about 2% shrinking. 4/3/2019 1700 Added Hood V3 merged and just the bottom half, I have yet to print v3 but I would do with rafts if merged. I will print V3 bottom half and glue it to version 2. The thought was I can added aluminum tape in it for extra light via reflection. Version 1 did not fit the LED solar lights very well so I had to wrap blue tape for a snug fit, then I thought why not do two lights. The slotted ends of the two and three inch risers only go one inch deep, the non-slotted end goes all the way. Press fit the pins in and use the lock blocks to stabilize or glue. Scale as needed. My planter pictured is 75% the 2/3 inch risers were based on that and are loose for easy removal. This is a work in progress. This is a Solar panel and single LED light holder for indoor growing. It's based on https://www.thingiverse.com/thing:903411. I'm not remixing it, I'm adding to it. So far I am making a hood that will be above it supporting the LED light with battery and solar panel. (Wal-Mart has them for $0.97US, couldn't find a link, and the 99cent only store also has them). This design is based on previously mentioned planter, but my printer cant print that size. I have previously printed this design at 60%, I am now, as in right now printing it again at 75% (now shown), The first half is done printing and I have been using it for my measurements.
Statistics
Likes
9
Downloads
0