Armattan Gecko BetaFVP LED board Mount
Description
printed one of Kodiak1120's led boards for my Diatone gt-r349 rabbit, and decided that it would work well on my Armattan Gecko. My Gecko has my rear buzzer mount on it, so this is designed to fit flush against the buzzer mount and allows a gap between the top of the bottom plate and the top of the hole for the wires to pass through. It mounts to the bottom of the quad sticking up, and I replaced the stock screws with a couple of m8 screws. print in petg.. I'd like to print it in tpu, but vhb to attach the board to the mount doesn't stick very well.. I might have a go at a tpu version with a slot in it for the board to slid down in a groove, but will see- the current one is working fine. on a side note I broke the one on my Diatone, and had to replace it- didn't want to re-solder the wires, so I just snipped a piece out of the top bar to fit the wires through and that looks to have worked fine. ok went ahead and designed it- added a tpu version where the board slides into the mount after printing it, it needs a minor tweak the hole for the led's is a tad small so removed the v4 and added a V5. after crashing my diatone again, if the board is pointed down on it, the battery slides back and breaks the mount, so I will be releasing an improved version of that one shortly
Statistics
Likes
6
Downloads
0