Anycubic Chiron 400x400 Leveling Circles
Description
This is the quickest way to level your Chiron bed 400x400 version not the 400x380. This print takes about 25 minutes and prints a 1 layer circle on the 25 points that it does its leveling. 1 - Do a manual leveling so the bed is somewhat level. Use a sheet of paper and level various points. Besure to have the bed heated. 2 - Follow Anycubic's instructions for doing an auto bed leveling. - https://www.youtube.com/watch?v=RudXmCgobso&t=49s 3 - Instead of using their "Level_Test.gcode" use this one. 4 - As the outer ring is printing goto Tools - More - Level and begin to lower until it is close. This can be as much as -1.50 or -3.00 Do not go too much. Every printer is different. I usually stop the print and will start again before the circles start to print till the outside lines start to stick. 5 - I then let it print all 25 circles. I try to take a marker and number them like the grid. They tend to pop up and you do not know where they went. 6 - If there are gaps the print head needs to be lower -. If is is solid but very bumpy usually the print head is to close and you need to add space +. Do this print as many times as needed till is is right. Sometimes takes 2-3 times, other 4-6. I also level with the material I plan to be using (PLA, ABS, ETC..).
Statistics
Likes
333
Downloads
0