openBulletFeeder Control Box and add ons
Description
This is a variation of tom_penn's electronics box for the Open Bullet Feeder. Original AmmoMike83 OpenBulletFeeder https://www.thingiverse.com/thing:2504314 My reloading press(Hornady LnL) is mounted to a mobile support, and I wanted the Open Bullet Feeder to be mobile as well. This electronics box accomodates that. This box was meant to be mounted to the supporting rod for the Bullet Feeder, but can be used on the table next to the press as well. The lid is designed to have no tolerance from the base. When printed, which I would suggest you print them facing the same direction, the lid will snap on and hold onto the base fairly securely, the screws just keep it all there. All connections use a 5.5mm x 2.1mm DC Barrel connector. ****Wire Cover**** The wire cover used a cheap 12-volt dc 2.1mm Car Cigarette Lighter Power Plug Cord Adapter which can be found cheaply on ebay. https://ebay.to/2Xv3nBm Once taken apart, the rubber wire retention will fit snug, when screwed to the base of the Openbulletfeeder. Sized for m3x20mm screw with nut. ****Jig*** The jig was used to help align the holes on the Hornadly Lnl AP press, with where to drill on the 3/4in rod. ------------------------------------------------------ Parts: 12v DC Motor Speed Controller - https://www.amazon.com/gp/product/B00QGMESHM/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 (*I would suggest a different jack, these are short which leaves the plug partially exposed*) 2.1mm x5.5mm 2 Pins DC Power Jack Female - https://www.amazon.com/gp/product/B012IJ35VQ/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 Round Rocker Toggle - https://www.amazon.com/gp/product/B012IJ35VQ/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 Torx Rounded Head Thread-Forming Screws for Plastic, Zinc-Plated Steel, Number 0 Size, 1/4" Long - https://www.mcmaster.com/99512a111 Plus Electrical Wire and Connectors, I chose to solder everything except the wires to the Rocker Switch. ------------------------------------------------------ edit 4/5/19 - added a version of the cover without holes, to be drilled yourself. edit 4/20/19 - added wire cover Jig_.75in_square.stl(M6 screw hole) Jig .75 square .75in hole.stl(3/4in hole for bolt on Hornady LnL AP) ------------------------------------------------------ If you all would like to customise it for yourself, feel free to download my design. Fusion360 Design: https://a360.co/2OtYWDp
Statistics
Likes
43
Downloads
0