Fritz Fon C5 Belt Clip Two Parts
Description
Hej fellow Makers! All existing belt clips for the Fritz Fon C5 on Thingiverse are one-piece and therefore only partially suitable for FDM printers. If you print along the clip, it's stable, but not the cover and vice versa. The clip of these models likes to break along the layer line, so I designed a two-piece clip. Depending on how accurate your printer is, you still have to sand a bit with fine sandpaper until it fits and to smooth out the possibly sharp edges. One drop of superglue and it's stable as a one-off. The shell maybe could be fixed with a strip of double-sided tape to the phone for firmer fit. Enjoy! If you have an improvement proposal please leave a comment. Unfortunately necessary: No liability for damage to your device! Use at your own risk.
Statistics
Likes
3
Downloads
0