Approximate 53mm Prop Cutter for Shendrones Nutmeg
Description
# THIS THING IS NOT TESTED Dremel prop cutting tool, designed to cater prop/duct proximity requirements for Shendrones Nutmeg quadcopter frame. No moving parts to virtually eliminate tolerance / backlash issues. Insert 5mm drill bit or standoff from your frame kit as prop shaft. Use rightmost hole to cut down your props to a slightly oversized diameter - 53.25mm, where duct opening measured from Nutmeg STL is very close to 2.08"/52.832mm, then progrssively use remaining holes to trim down to target size in **0.125mm RADIUS increments**. Modeled after a Dremel 4000 using **3mm** milling bit.
Statistics
Likes
12
Downloads
0