BeaverUP: Dual-Z X-carriage mount for CR-10, Tevo, Ender
Description
I designed these X-Carriage mount for a friend of mine and his CR-10 dual-Z, belt driven setup. The main features of this project are: - it's **compatible with anti backlash nuts** but you can even use the **stock nuts** - **reduce zwobble**: these mounts have some little slinding area where the leadscrew nuts can adjust their position and **fine tune**. For the same reason it also **reduce noises** - leascrew can be installed both ways, with **motors on top or bottom**. Because of it there are two different models you can print: with *nuts on top* or *nuts on bottom*. - you can use the **stock feeder** or even a **bondtech BMG** without any changes and the **overall print height is unaffected** - it's **solid** but **minimal** at the same time so you will need **very little filament** to print these models - it's **easy to print** because it does **not require any support** - it's even **compatible with dual extruder** setups if you mirror the left motor mount in your slicer. Likewise is **compatible with direct-drive** setups if you mirror the right mount and print two brackets without motor support At the moment is successfully installed on my friend's **CR10-mini printer** but since it's actually similar to Creality and Tevo other models setup we think you can install even of those printers. Let us know if you succeed or not!
Statistics
Likes
247
Downloads
0