Test for Pressure Advance
Description
I´ve made this model to calibrate pressure advance by looking at inner and outer corners "blobbing" similiar way that used to calibrate pressure advance on klipper. I added some extra corners with diffrent angles to expose the set value better.. In order to reduce first and last layer effects I used chamfers to further increase focus on only the middle layers by romoving first and last layer artifacts. It consist of the following angles: - 30 - 45 - 90 - 135 - 150 - and 2 cuts in diffrent sizes which are 3 mm and 1,7 mm in width
Statistics
Likes
7
Downloads
0