CR10S Legs
Description
There are plenty out there but I wanted something not so over engineered. My CR10S has rubber feet so the top cup will fit this. 3 versions, I prefer the look of the circular cutouts but probably the square prints better. Cut out to reduce material, it not doing anything for stability and should reduce print time a bit. 6.04.19: UPDATE: Version 3 added a section across the top that can be printed as a bridge for better quality. The target is to print without support and the initial print with a hanging corner managed to print but quality was not great. That said the section that takes the actual weight was a virtual bridge and is super strong. I am printing in single legs with no support. The small outer section of the box although hanging in space printed with acceptable quality so no additional support there. I kept the bridge distance to 20mm so fairly easy to manage. Sliced by Cura in PLA normal with speed reduced to 50, 10% fill. 6.04.19: Final version increased the foot side to 22mm for an easier fit over the CR10S rubber feet. Feet fitted and controller fits under the printer now. Next job to move the print spool and tidy the cabling. Dave
Statistics
Likes
35
Downloads
0