FlashForge Creator Pro Cooling Fan Duct - No Frills, Flexion compatible
Description
### Purpose This is a no-frills cooling fan duct that works on a FlashForge Creator Pro (there are a number out there that are really good) that works with the Flexion HT print heads (small clearance). This cooling fan duct can be printed with no pre-existing cooling fan and can easily be cleaned up. No supports are required. ### Additional parts for cooling fan duct * 4010 (40mm x 10mm) cooling fan. 24v required for FlashForge Creator Pro. Typically rated at 0.1A 6000+ RPM. * 4x M3 18mm bolts * 4x M3 nuts * Connector to match fan cable - I used JST SYP 2.54mm Female crimp-style (e.g. through Amazon B0188YKCFC). ### Parts required if wiring for fan for first time * Suitable wiring, e.g. 22awg black/red cable (I used this through Amazon B00QTCBZ4I). * Suitable connectors to attach to fan near print head so that fan can be removed (see above). * Nylon zip ties to replace any that needs to be cut (I used 8 inch black) * Creator Pro requires 5.08mm 2 pin screw terminal blocks (I used Amazon B01MG4FC6E).
Statistics
Likes
6
Downloads
0