Corner brackets for Ender 4
Description
Thought my Creality Ender-4 was a little wobbly and got a little Z noise because the bed z-rods wasn´t supported enough and the hole thing wasn´t as stiff as I wanted, especially for large prints at higher speeds First I printed this thing https://www.thingiverse.com/thing:2572407 and it works great, but it just wasn´t quite enough So I designed these corner brackets and they work magic. they might fit the Ender-5 too and other printers with the same extrusions You´ll need a lot of 5mm screws and T-nuts Bracket 1 is for the corner without the little metal bracket inside the extrutions. Bracket 2 is for all the corners where the metal bracket is in place as in all the top corners
Statistics
Likes
16
Downloads
0