diamond lapel pin / badge
Description
Little diamond pin. Printed on a Flashforge finder, no special settings. Two options - 1) print the flat pin and glue on a pin back. For this one, use the flat diamond file, and pause the print at 2mm to change the colour. 2) print the version with the stud attached. This one is upside down so you will be printing the diamond image first. Pause the print at 1.1mm and change the colour for the rest of the pin and stud part. Note because you aren't printing the rest of the base on a solid surface the finish is a little textured, but I quite liked that. Gently remove from the print bed with a palette knife to prevent damage to design. This one is a work in progress, comments/suggestions welcome.
Statistics
Likes
18
Downloads
0