Missions Vibroblade Inspired Backer and Pommel
Description
This is my take on the backer for the KOTOR vibroblade back. its meant for my wooden blade that was made by my friend. the measurements on that blade are 28in long from tip to guard and 3/4in wide at the spine. the bevel/taper for the cutting edge is a half inch and begins 1.25in down from the spine where this accessory caps on this accessory is meant to be 13.75inches long to fit my specific blade. your mileage may vary and you can scale it to do what you need. I left some areas open to show the base of the blade where the paint will make the different shades shown in the stock photo I found on the internet.
Statistics
Likes
13
Downloads
0