raptor 2 blower duct modified
Description
so I re designed the blower housing on the raptor 2 and this is what I have I am still testing for correct flow but this is hands down better than what was on there. need to orient the model flat and the blower hole facing forward toward you when looking at it. then set your system to seam at the x0 y0 coordinates . in s3d when printing in optimize mode it does some funny stuff starting on the 1st bridging layer that covers the top of the blower horseshoe. so by doing this and setting the z seam you wont have an issue … also this is designed to fit with the e3d silicone sock on the heater block to have clearance the factory one didn't Vs 1.2 the latest one is the new blower shroud should be a blast
Statistics
Likes
6
Downloads
0