Mega Rollerz - Anycubic i3 Mega spool holder
Description
Tried to find a spool holder for my i3 mega but did not end up with one that worked as I wanted. So here we are again and tried to design one that was more suited for what I need. So I wanted a roller model and after the first few prototypes I ended up with this. The covers on the front of the rollers are so that the filament does not ride the rollers as it feeds. There isn't that much force on the individual rollers but I added some additional support to the inside to compensate if it starts to shift as time goes by. Snaps in place in a satisfactory way, hope the frames on others don't deviate too much. There are two variants of this spool holder: 1. First one (Frame_through_hole) with a normal through hole for a M8 x 25mm hex bolt and use a nut on the other side. 2. Second version (Frame_tappable) is for tapping the hole with M8 thread and optimal would be a M8 x 18mm but I ended up using a M8 x 16mm hex bolt instead and works just fine. Mirror the other side in your slicer To assemble you will need - 4 x M8 hex bolts x 25mm for fastening with nut or M8 x 16 - 18mm if threading the holes - Appropriate tools
Statistics
Likes
9
Downloads
0