XT60 Panel Mounts
Description
Here are are some XT60 panel mounts with 2, 4, 6 & 8 way options. This works equally well with both male and female connectors. I reused the connector clamp from kisolre's design here https://www.thingiverse.com/thing:3215358 but shrunk the connector hole walls as the fit was a bit too loose for my liking. I printed it in PLA with 100% infill at a 0.3mm layer height on the Ender 3 without issue. The connectors are held in place with short m3 screws and nuts. I hope you find this useful. Enjoy! :) Updated 06/06/2020: 1) Increased plate rigidity by adding bridges between sockets & increasing plate height by 0.5mm. 2) Improve assembly by flipping the screw & nut positions midway. Use a long screwdriver or hex key through outer holes & assemble from middle outwards each side. 3) Increased socket clamp reach. 4) Added 6 & 8 way options.
Statistics
Likes
95
Downloads
0