Robo3D Hexagon Extruder shrout Fan to 40mm
Description
My 25Mm Extruder Fan Went Out. I Created This From Cardboard First, It Worked Well Enough To Print This Shroud Out. I Cut It In 2 Parts, You Can Glue Them Together. I Printed With Support. This Works Well. It Clips On Fairly Tight. I Did Not Screw It Or Glue It At All. The Only Thing I Did Do, Was Use Some Aluminum Tape (For Duct Work) To Fasten The Fan To It, As Well As A Bit Right Near The Hexagon Extruder For Heat Dissipation Purposes. It Is The Same Plastic That The Extruder Melts After All.
Statistics
Likes
10
Downloads
0