Final Duct Fan for CR 10S Pro
Description
Premise: After having reprinted the original Creality fan duct (for CR 10S Pro) because the bottom was too rough and could create problems, I also noticed a slight deformation of the beak due to heat from contact with the hot-end (see photo) Solution: In order not to distort the original Creality specifications, the simplest thing is to cut the beak near the hot end. I also analyzed the problem of the material used by Creality (PLA) not really adapted to this type of object, given the proximity to heat sources, I opted in the first step to PET / PETG. Conclusions: I observed the many solutions on this portal, very elaborate and complex, choosing, for now, for the simplest solution and closest to the idea of the designers of Creality. Sure not the only one, but I wanted to give my modest contribution to the community. Thanks for your attention, and have fun. Alla Prossima, S.B.
Statistics
Likes
59
Downloads
0