PROMEGA ADJUSTABLE NOZZLE FANS
Description
https://www.facebook.com/groups/1156304777857840/?ref=bookmarks This is for 40mm nozzle fans. I recommend printing at .2 layer height with .4 nozzle. Prints as one part. Use a 3m screw or bolt to drive it up or down. I normally leave a .3mm gap but everyone complains that the parts won't come apart. I don't recommend printing with PETG because it will likely adhere together. I got a nice print and it detached nicely. Once printed pull the 40mm fan ducts down insert the bolt at the top. Should be plenty of room to just slide it down. Then start screwing into the duct/nozzle fan shroud drawing it up. This is untested because I don't have a ktana but you can try it out. I have 1 concern. Vibration noises. There is a hole on the inside of each duct that you can put a screw in to stabilize but you may not need it. Let me know what you think in the comments.
Statistics
Likes
5
Downloads
0