RCExplorer Bicopter FPV Canopy V2
Description
#Bicopter FPV Canopy This is a revamp of my original Bicopter canopy design. Allowing the camera mount to be removed independently of the frame as well as having a much better door / hatch to access the electronics. My prior build: https://www.thingiverse.com/thing:3379928 * Camera Tilt range of +40 to -10 degrees. * Mount can handle most any 20 mm wide camera. * Hatch pivots open to allow access to internals. * Video & Receiver electronics can be mounted to underside of Hatch, having both 20 x 20 and 30 x 30 mount holes. * Spacers are used to steady area around camera for extra strength. * Entire canopy is made to slide over the frame / carbon rod to allow for easier installation and maintenance. Be aware that this canopy 100% requires RCE Bicopter frame and winglets. For best printing results, Oynx-CF is ideal. Yet, Nylon and ABS will work too. See the following thread for further details. https://rcexplorer.se/forums/topic/bicopter-camera-mount/#post-60958 Video of one of my flights but be aware that my self leveling acted up as I was trying to land. Had to ditch it to keep it from flying off. https://www.youtube.com/watch?v=Dz4hZWaoE20
Statistics
Likes
15
Downloads
0