MDFLY RJ45 Breakout Board Mount
Description
This is a mount for an MDFLY RJ45 Breakout Board to be used with https://www.thingiverse.com/thing:2054098 by Dan3Dmaker. https://www.amazon.com/Ethernet-Connector-Breakout-Board-terminals/dp/B072J59H5X/ref=lp_10211163011_1_15?srs=10211163011&ie=UTF8&qid=1555578055&sr=8-15 Using two M4x16 screws, attach the mount to the top two rear holes of the carriage. Using four M3x8 screws, attach the board to the mount. I printed this vertically so that it would not need any support other than what fills the screw holes. It needs to be oriented so that the 45-degree angles are angled upwards.
Statistics
Likes
0
Downloads
0