Gmade R1 Portal 7 & 13 Degrees C-Hubs

Gmade R1 Portal 7 & 13 Degrees C-Hubs

Description

** This is a printable version of the alum. 7-degree C-Hub that Gmade sells as an upgrade** ** I have made a 13 degrees version too now, since 7 is not alot..** V2 Files are now corrected and should be fine to print. Tolerances around the outer edge are corrected (Was a problem in previous version). If you print it in Nylon, PETG, ABS, it should be plenty strong. Your choice of 7 or 13 degrees : * Complete Left and Right * Split Top/Bottom Left and Right (No supports) * - (Glue the parts together after the print) * Or the newer and better WrHubs ! --------------------------- ** UPDATE 2019 ** : I found the "Wrapters" which allow the use Axial AR60 cHubs/knuckles/universals for more steering throw. After 4 of them broke in not even a day (weak where you screw the cHubs into the adapter) i decided to remove that weak part entirely, effectively making a "WrHub". Cut the shafts to the same length, use the same tube for shimming as in the Wrapters instructions. 1 Additional 5x8x2.5 bearing needed per side (2 total) (same as those already in the portal box).

Statistics

Likes

17

Downloads

0

Category

R/C Vehicles