Look Keo Cleat Placement Holder - 0 degree
Description
If you run Look Keo pedals with black (zero degree float) cleats, these wedges act as a placeholder for you when replacing. Lay them flat on the sole of your shoe BEHIND the cleat (the heal side), push into the cleat until there's no wiggle, tape it down, unscrew the cleat, place new one on shoe lined up with the wedge, and tighten cleat back down. Clean the cleat/shoe area of course so there's a tight fit between the cleat and wedge. I still trace the cleat but these are working much better for me. I only use black cleats, if I get some of the other colors over time I'll make wedges for those as well, the angle is different for each. Printing quality shouldn't matter as it's not a stressed part, I used 20% infill with maybe a 5 shell since it took so little time to print either way. Hope this helps!
Statistics
Likes
2
Downloads
0