HeNe Laser Shutter
Description
Laser safety shutter replacement for JDSU and Lumentum 1100 series lasers. The original shutter has a short control surface that can wear down over time. These lasers are also known as Helium-Neon or HeNe lasers. Recommend print settings: ABS Filament .2mm resolution 100% infill with 3-4 layers for exterior, top and bottom features. IMPORTANT! (Tap center hole of print with a 1/8" drill bit) ***Part Replacement*** Step 1: Remove (4) .05" set-screws and then remove the end cap containing the laser shutter. Step 2: Using a small pick or flat bladed screw driver, remove the one way washer and flat washer. There will be a wavy washer under the shutter. Step 3: Install wavy washer, replacement shutter, flat washer and one way washer in that order. Step 4: reinstall the 4 set screws. Done!
Statistics
Likes
0
Downloads
0