Fidget Gears V2 Keychain Print In Place
Description
Update 2029-07-21: added post print section. After all the updates to my Anycubic I3 Mega-S printer I'm now able to print this at 100% size! Updates on Printer were: TMC2208 Steppers, Marlin 1.1.9 Firmware, new part cooling. Important parameter for print quality is "Outer walls before Inner walls" Update 29.04.2019: fixed the issues in comments in "*KeyChain2_*" This is a KeyChain Remix to not easily loose it. Never again drain your Car-Keys Battery, as you have something else to play with :) Printed _BasicSupport at 120% to have Name-Plate printable with 0.6mm nozle. -ABS Innofil3D Silver -ABS Ultimaker Black -Concentric Support from BuildPlate, 1.4mm line distance -25mm/s Wall speed (Slow) -prints in 2.5hours -1.75m Material 2.85mm Filament I used Two Colors to proof it's printed in place ;) Would like to see this printed in Rainbow Filament (but you would need more than 4 to have a smooth colorchange, as it's not that much filament :) Please post a print if you like and tip the Designer :)
Statistics
Likes
1782
Downloads
0