1-10 RC Two-piece JDM Tow Hook Design by SlantedRC
Description
I've designed this as a two-piece base and hook assembly. The idea behind the design, is to allow you to install the base to the inside of your shell using glue and line it up without destroying a large section of your shell. A 7mm dia hole is required for the hook to slide through. Install, allign and glue the base using epoxy glue and install, line up and secure the hook using either a small screw to split the "splines", or epoxy, or superglue. The dimensions used should fit nicely on most models. Product is yet to be printed, tested and reviewed, and potential flaws on drawings may still need to repaired. I rely on your feedback to fix any issues with any of my designs, and appreciate any and every comment you can provide - THANK YOU IN ADVANCE. Should you have a custom request, please get in touch. I will gladly assist where and when it's possible. This design was published to be used and printed free of charge and not to be distributed or sold for profit. (My contribution to RC Hobbyists to try and keep it as affordable as possible). Printing, installation and usage is done at your own risk. Please post a photo of your installation on our Facebook and Thingiverse wall if you opted to use the design. Facebook: https://www.facebook.com/SlantedDriftSquad/
Statistics
Likes
17
Downloads
0