Anet A8 Clone 5mm Frame Stabilizer
Description
I always thought that what I had bought was an Anet A8. Then after looking at everyone's descriptions, they all had frames that were made out of acrylic. Mine was sent to me with aviation ply wood. Every time I downloaded a design, the things that I printed didn't fit because the acrylic was much thicker than the plywood that mine was sent with. So i figure that I bought some clone. Therefore, I measured mine this morning with my calipers and used that measurement to adjust this design. My frame is all 5mm thickness, therefore, I made the gap in this design 5.3mm, so It wouldn't have to be hammered on, but would be snug enough that it wouldn't slide off. Hope this is helpful for all the people out there that have the same issue I have. -Thanks to pparsniak, for making such an elegant looking design. This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/0yThg2uMnmv
Statistics
Likes
1
Downloads
0