Parrot Bebop 5mm Prop Adapter
Description
I created this adaptor so I could use standard 5mm drone propellers. For motors spinning clockwise use CCW and for motors spinning counter clockwise use CW. The nut is clockwise, for the ccw just use mirror in slicer to print a reverse threaded version. Remove props, take out the 3 screws that were holding the old prop on and use them to fasten the new adapter hub down. These print fine with PLA at 100% infill at fine resolution, they are a little snug so you mat want to use a steel m5 screw to open the threads a little or upscale just a hair. Enjoy!
Statistics
Likes
11
Downloads
0