CR-10 / Ender 3 Dual 40mm Volcano Part Cooling Fan Ductinator
Description
This is the Volcano version of my dual 40mm part cooling fan thing: https://www.thingiverse.com/thing:3594440 To those that don't know, volcano heat blocks screw right on to the standard CR-10 heat break. In my case, I was running a Micro Swiss all metal hot end, and was Volcano curious when I made the realization. So I have the super good performing Micro-Swiss all metal setup and their titanium heat break feeding into an E3D Volcano clone heat block. This setup works wicked sweet. The logic behind my design is that big fans running slower move more air, more quietly, than small fans at full speed. For normal printing I run the fans at 50%. But if I want to print fast with a fat volcano nozzle, those I can throttle them up for big fat thick layers.
Statistics
Likes
75
Downloads
0