Low profile toolless Prusa i3MK3/S squash ball feet damper vibrations/noise isolator
Description
You may find two versions of .stl attached: - v2 which is higher (about 4 mm regards to v5) and tighter in tolerances, what results some minor problems during mounting into the profiles, - v5 which is lower and fits not so tight as v2 (easier to mount). If your printer is heavy loaded by filament spools (or by other equipment) at the back side than I recommend to use v2 feet at the back and v5 at the front. I found some inspiration to design damper feet when I saw these things: https://www.thingiverse.com/thing:3385254 https://www.thingiverse.com/thing:2450161 https://www.thingiverse.com/thing:2980350 https://www.thingiverse.com/thing:3173854 https://www.thingiverse.com/thing:2823821 My version is low profile, toolless, screwless :) and a little optimized, regards to another squash ball feet I found on Thingiverse. Print, push in the ball (marked by 2 yellow dots) and mount in the aluminium profiles of your Prusa without any additional tools or parts. It should fit another 3030 extrusions as well. **EDIT 27.04.2021** I decided to add v6 which is this same as v2 but a little upgraded for better tolerances, so it's easier to mount, just like v5. I recommend to use v5 and v6 only.
Statistics
Likes
58
Downloads
0