OpenRC F1 Reinforced Nose with embedded M3 Nuts
Description
I was having trouble sliding the m3 nuts into the original nose so I have made it so that you embed the m3 nuts into the part as it prints. Another problem I was having with the original design was that after hard crashes the nose would snap in half along the layer line (vertically). This part needs to be rotated 105° and printed with the bottom facing down which makes it less prone to snapping in half along the layer lines and more resistant to crashes in my experience. However, after having attached a reinforced front wing, the nose needed a bit more strength to survive the more violent crashes so I've also made a reinforced version of the nose where I've reinforced the areas that were breaking.
Statistics
Likes
4
Downloads
0