anet A8 Z-axis endstop position adjuster
Description
You can adjust position of z-axis endstop switch. 1. Insert M3 nut in to the middle slit of slider. 2. Put M3 nut in to the hole on the front of the main body part. 3. Screw M3x18mm thread from back of the main body and fasten the thread for the crank. 4. Insert crank hole through the pin. 5. Put the slider into the crank. 6. Insert M3x60mm thread or something. 7. Use the original flat head threads and bolts for the main body part. *) 8. Print something. *) You can use full thread instead of 60mm thread screw. In that case, you will need to design nut holder or download my design and print to turn the thread. If you use M3x60mm thread, and you want to adjust by your screw driver instead of your finger, you don't need to print the nut head I designd. In any case, you need 2 nuts(and washer) to prevent moving in the axial direction of the thread at the end of the thread.
Statistics
Likes
9
Downloads
0