Nespresso pod gasket mold for OriginaLine pods
Description
For fans of the Nespresso line of coffee makers who prefer to fill their own pods. Due to a combination of ordinary wear and tear on older machines and the hard plastic construction of many fillable pods, Nespresso machines may tend to leak from behind the pod resulting in low espresso volumes and poor extraction. This form will allow you to mold your own reusable silicone gaskets for use with Nespresso OriginaLine-compatible pods. After printing, reservoirs can be filled with clear or colored silicone caulk. Use a kitchen/bath caulk that contains acetic acid. After filling reservoirs, use a flat edge to scrape off excess caulking. Gaskets cure enough to be removed after a couple of hours, but may be tacky unless left overnight or equivalent. In my experience, the silicone doesn't stick to ABS. For best results, clear the excess surface material from around and within the gasket perimeter before removing gaskets from the mold.
Statistics
Likes
2
Downloads
0