HPI Venture Rear Shock Towers With Narrow Body Mounts
Description
I made these narrow shock towers so that I could use the Proline Power Wagon body with the HPI Venture. You'll still need to cut up the bed a bit to get it to clear the shock towers but with the body posts moved inwards it retains some strength, otherwise the body mount holes are very close to the edge of the cut out for the shock tower. IIRC the body mount points have been move inwards 7mm on each side. I've also lowered the body post mount by one hole which was as low as the body can possibly go without reworking the rear suspension setup.
Statistics
Likes
15
Downloads
0