Apple Watch Stand -Thing by MikeVR - Split
Description
This is just a split version of MikeVR's Apple Watch Stand - Thing. Split the design in two so smaller printers can fit it. I have not tested the print yet and will upload pictures once I do. If my design is correct, the pegs should line up making gluing a lot easier. STL's probably need to be repaired by splicer. Edit 1 - So I printed it and it worked, I might play around with making the pegs tolerance a tad tighter. Right now the hole is 1.5mm bigger and it works but can be better. I might also change where the seam is located, it currently is just below the middle mark which allows it to work with most medium sized printers.
Statistics
Likes
108
Downloads
0