Vidroc SQ11 Camera Mounts
Description
<h1>Vidroc SQ11 camera mount</h1> <B>Update</b> - Added a BT-50 nose cone mod for this camera. - You have to print the nose cone with supports. - Either glue or screw the camera mount into the notch in the nose cone Simple set of mounts that allow you to mount a [SQ11](https://www.amazon.com/s?k=SQ11&i=electronics&ref=nb_sb_noss_2) onto your airframe using either nylon straps or a countersink screw. The SQ11 is a remarkably small 1080p camera - a little of a pain to activate but once you get used to it, it's not so bad. (did I mention these are CHEAP, too?) The camera fits in VERY firmly but I included a small hole for a tiny set screw if you need to secure it more. (My prints are so firm I have to use a small flat tip screwdriver to pop the camera out) There is a small custom support you need to cut out after printing. <img src= "https://cdn.thingiverse.com/renders/f3/bc/87/2e/6e/855ea75e50ca6815f24640d6df868cae_preview_featured.jpg" alt="remove dis" title="Title" /> If you use this post you videos in the comments!! Here is the Fusion 360 file [Vidroc SQ11](https://a360.co/2J7tNpE)
Statistics
Likes
20
Downloads
0